In the device tree, the last value of the primary channel is always displayed below the sensor's name. Select a channel from the list to define it as the primary channel. For some sensors, you can explicitly define the monitoring target in the sensor settings. Usually, a sensor connects to the IP Address/DNS Name of the parent device. Choose from the lowest priority ( ) to the highest priority ( ). The highest priority is at the top of a list. This setting determines the position of the sensor in lists. The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor: Server 2012 run disk health plus#It is not possible to enter tags with a leading plus ( +) or minus ( -) sign, nor tags with parentheses ( ()) or angle brackets ( ).įor performance reasons, it can take some minutes until you can filter for new tags that you added. You can use tags to group objects and use tag-filtered views later on. Confirm each tag with the Spacebar key, a comma, or the Enter key. You cannot change it.Įnter one or more tags. This setting is for your information only. Shows tags that the sensor inherits from its parent device, parent group, and parent probe. The settings that you select in the Add Sensor dialog are valid for all sensors that you create when you finish the dialog. You can change nearly all settings on the sensor's Settings tab after creation. It only shows the settings that are required to create the sensor. The Add Sensor dialog appears when you manually add a new sensor to a device. If you want to use this sensor, add it to a remote probe device. You cannot add this sensor to the hosted probe of a PRTG Hosted Monitor instance. This sensor supports the IPv6 protocol. Server 2012 run disk health windows 8#
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |